Cordier Frequensator Split Tailpiece Archtop Hollowbody Vintage 40 Gold

WD® Replacement Frequensator Split Tailpiece For Epiphone® Guitars

This tailpiece was know as the 'Frequensator' and originated in the 1940's. It was and still is used on many archtop guitars including instruments by Epiphone®. The large mounting bracket is flat on the side the screw holes are drilled and includes the center 4th hole for the strap button. There are two hooks for each long and short trapeze on the opposite end of the mounting bracket to securely attach the trapeze sections where string tension holds them securely in place. The hex nuts on the threaded ends of the trapeze sections hold the string mount brackets in correct position. Available in Chrome, Nickel, or Gold, mounting screws included.

Spécifications: Support de montage Largeur de la plaque avec vis de montage = 2 17/32 pouces (64,3 mm)

Longueur du côté du support de montage avec trous de montage = 1 39/64 pouces (41 mm) de l'extrémité au coude Longueur du support de montage du coude à dessus de crochet trapèze = 1 13/64 po 30,5 mm)

Longueur du trapèze court jusqu'au haut de la barre de retenue de la corde (sans les hauteurs d'écrou) = 2 1/2 po (63,35 mm)

Largeur courte du support = 1 3/64 po (26,65 mm)

Largeur du support de cordes = 1 3/16 po (30,35 mm)

Longueur de la longue section de trapèze avec support de cordes = 6 po (152 mm)

Les largeurs de chaque trapèze et support de cordes sont égales